DSC & SCI Convention Booth Locations

Are you headed to this year’s Dallas Safari Club or SCI Conventions? Stop by our booth and say hello!

We will be in Booth #4048 at DSC and Booth# 4518 at SCI. Hope to see you there!

Important Information Regarding Industry-Wide Brass Shortages

While we have seen some improvements on the availability of components recently, we are still experiencing shortages on brass components for a variety of calibers.

Please note that both Winchester and Remington have not made brass available in component form for many calibers in over two years. Due to this fact we must use either Bertram, Hornady, Lapua, Norma or Nosler custom brass for the following calibers:

  • – 7mm STW
  • – .257 Roberts
  • – .260 Remington
  • – 6.5×55
  • – 8mm Rem Mag.
  • – .350 Rem Mag.
  • All Remington Ultra Magnum Calibers
  • All Winchester Short Magnum Calibers

While the brass from these manufacturers is of very high quality, it is also expensive as compared to Winchester or Remington brass. Because of the high cost of these components, we must charge an additional production fee when producing these calibers. The “upcharge” for these calibers is between $8 and $20 per 20 rounds of ammunition depending upon the caliber. We apologize for this inconvenience, however there are no other options available to us at this time.

Please contact us regarding the status of components or  with any questions regarding the upcharge.

Double Rifle Regulating

Make Full Use Of Our Truly Custom Ammunition!

Remember to take advantage of our Double Rifle Regulating Service- please view our Featured Services Page for more information.